Codan-radio MT-4E Analog and P25 Digital - Maintenance Guide Instrukcja Użytkownika Pobierz pdf (Strona 44)

MAINTENANCE GUIDE | MT-4E ANALOG & P25 DIGITAL RADIO SYSTEMS

Chapter 5: Codan Radio System TestingPage 36

In the receiver RSS, enter the Service section and click on “Ref Oscillator”. The reference oscillator

frequency is shown as the “Target Synthesizer RF OUT”. Enter this RF frequency into the IFR 2975.

The receiver generates this frequency out of the Synthesizer into the IFR 2975.

Monitor the RF Error window on the IFR 2975. To change the reference frequency, adjust the softpot

slider in the RSS as shown in Figure 5-22. Adjust until the RF error is as close to 0 Hz as possible.

Click on the “Program” button to program in the new Reference Oscillator softpot value. The high and

low alarms are turned off.

Figure 5-22: RSS Receiver Reference Oscillator Alignment

Enter the L.O. Reference Oscillator Offset reading on the MT-4E Test Sheet.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 75 76

Brak uwag

Codan-radio MT-4E Analog and P25 Digital - Maintenance Guide Instrukcja Użytkownika Strona 44